Q-MULTIPLIER
by Harry Lythall - SM0VPO

A few weeks ago I posted to QRP@WW the modifications to convert a cheap radio to the HF amateur bands. I have dug-out one of my radio's that was modified for 7MHz and found yet another circuit was built into it. This is the circuit for a Q-multiplier to reduce the IF bandwidth. I do not have any idea where this circuit came from, but other than scribbled on the back of a cigarette packet some 20 years ago.

The circuit is basically an oscillator that does not quite oscillate, so when it is connectd to the IF HOT end of the first IF transformer it will increase the Q-factor, thereby reducing the IF bandwidth considerably. It does this by cancelling the losses in the 1st IF transformer using gain from an additional transistor circuit.

In the circuit given, T1 is a first IF transformer, from another one of these cheap radio's. The capacitor "c" is built into the IF transformer. Couple the output of this circuit to the 1 st IF transformer of the radio to be modified and peak the first 1 st IF for maximum received signal. Peak the transformer in the Q-multiplier circuit for maximum received signal then increase the 47K until oscillation just begins (you will hear a STRONG beat note). Re-adjust the transformer of the Q-multiplier for "Zero-Beat" (lowest frequency tone). Turn the 47K pot back until the tone just stops. That's it!!

Don't forget to turn the 47K pot to "zero" BEFORE you start tuning. You will now be able to hear the difference when you tune through SSB stations. The RX bandwidth is much narower, and reduces the adjacent channel signals to a more acceptable level. AM stations around 7.2MHz will now sound a bit muffled due to the reduced bandwidth.

This circuit will work well with almost ANY radio having an IF of 455KHz, but for God's sake DO NOT TRY IT ON A VALVE RECEIVER!! The high voltages could be lethal.

Dont forget to visit my messageboard if you have any questions about this or any other project. I always look forward to receiving feedback, positive or negative. You do not have to register to post messages.

Very best regards from Harry Lythall
SM0VPO (QRA = JO89WO), Märsta, Sweden.
EA/SM0VPO (QRA = IM86BS), Nerja, Spain.

Return to INFO page